In order to correctly size a hydraulic cylinder on a mold, follow these steps.
1.Train the mold designer to understand the potential maximum plastics pressures, so he/she can accurately calculate the plastics pressures that the cavity surface area will have on the component. Many will look only at pack/hold pressures, when peak plastics pressures must be considered. Also, do not solely base it off the material being used, as there are factors that can drastically impact pressures. If you are unsure then round it up. Note, if you want a robust tool and process then do not ever round it down. Once you have determined the maximum plastics pressures, the rest is easy.
2.Accurately calculate the cavity surface that is on the surface area of the component. Then multiply that number by the maximum plastics pressure we discussed. The result will be the required pressure for your hydraulic cylinder design.
3.Determine the honed bore size of your cylinder. Typically, I will design the bore size so that it exceeds the cavity pressure force by 1.5X to ensure robustness. For example, if expected cavity pressure was 10,000 psi and the cavity surface area of the component was 1 square inch, we know that there would be 10,000 pounds of force acting on the component (10,000 pounds per square inch X 1 square inch). If we multiply 10,000 by 1.5 ratio, we find that we need approximately 15,000 pounds of force to counteract the cavity pressure.
